Air-energy heat pump noodle dryer - drying high-quality noodles

Air-energy heat pump noodle dryer is a new type of high-efficiency and energy-saving drying equipment. Its working principle is based on the reverse Carnot cycle principle, using a small amount of electricity, using the compressor to absorb a large amount of heat energy in the air, and evaporating the working fluid into a gaseous state in the evaporator after passing through the expansion valve. The gaseous working fluid is compressed into a high-temperature, high-pressure gas by the compressor, and then enters the condenser to release heat to heat the drying medium. In this way, the continuous cycle heating saves two-thirds of the electricity compared to the electric drying machine.

Features of air-energy heat pump noodle dryer:

1. Air-energy heat pump noodle dryer integrates dehumidification, heating, cooling, exhaust and ventilation as an intelligent device, which is a new type of energy-saving and emission-reducing drying equipment.

2. The intermediate heat exchange and dehumidification of double-effect dehumidification technology greatly improves the dehumidification performance ratio, and the energy-saving effect is obvious.

3. Solve the technical problems of poor dehumidification performance or even idling (compressor operation without water removal) of traditional dehumidification equipment under high temperature and low humidity conditions.

4. More reasonable exhaust heat recovery design: reduce exhaust heat loss, better comprehensive energy saving;

5. Advanced fresh air pre-dehumidification function can ensure fresh air drying, suitable for strict drying process;

6. Air energy heat pump noodle dryer is an environmentally friendly and energy-saving drying equipment. It will not produce any harmful substances during the drying process, and there will be no smoke or open flames during the drying process. It can adjust the temperature and humidity according to the characteristics of the drying material, and has a high degree of intelligence.

7. There is no need for special personnel to supervise the drying process. After the material is dried or the drying temperature is reached, the unit will automatically shut down to achieve energy saving. The unit operates at normal temperature and pressure, and during the drying process, the unit will generate cold air. Directly discharging the cold air into the workshop can increase the room temperature.

8. Energy saving, long service life, only consumes a small amount of electricity, and can absorb a large amount of heat in the air.

9. Easy to install and dismantle, small footprint, can be installed indoors and outdoors.